HP NonStop NS-series User Manual

I/O Adapters and Modules: Monitoring and Recovery
HP Integrity NonStop NS-Series Operations Guide—529869-005
8-5
Monitoring the G4SAs
Monitoring the G4SAs
Use the Subsystem Control Facility (SCF) or the OSM Service Connection to monitor
the G4SAs.
For a general, top-down approach for using OSM to monitor system components, refer
to Using OSM to Monitor the System on page 3-7.
To monitor the G4SA and its attached devices with SCF, use the SCF INFO and SCF
STATUS commands.
For example, to monitor G4SAs using SCF:
> SCF STATUS ADAPTER $ZZLAN.G1123
The LAN Configuration and Management Manual provides reference details and
examples for using the SCF INFO and SCF STATUS commands.
Device State:
Initializing
Processing is starting up.
Device State: Not
Configured
The component is not configured.
Device State:
Started
The component is running.
Device State:
Starting
Processing is starting up.
Device State:
Stopped
Processing has been terminated.
Device State:
Stopping
Processing is being terminated.
Device State:
Unknown
Component is not responding.
Device State: OK Component is accessible.
Enabled State:
Disabled
The component is present but not operational, possibly because the
Disable action was performed.
Enabled State:
Enabled
The component is operational.
Enabled State:
Fault
A problem was detected. The component might be functioning below
standard or not responding. Inspect the component.
Enabled State: Off The component is not functional.
Enabled State: On The component is functional.
Enabled State:
Unknown
State is unknown; component might not be responding.
Table 8-1. Service, Flash Firmware, Flash Boot Firmware, Device, and
Enabled States for the FCSA (page 2 of 2)
State Description

HP NonStop NS-series Specifications

General

Brand	HP
Model	NonStop NS-series
Category	Server
Language	English