To Next Page

To Previous Page

I/O Adapters and Modules: Monitoring and Recovery

HP Integrity NonStop NS-Series Operations Guide—529869-005

8-7

Monitoring the 4PSEs

For a general, top-down approach for using OSM to monitor system components, refer

to Using OSM to Monitor the System on page 3-7.

For 4PSEs, the OSM Service Connection reports, in the form of attributes, the

•

Service State (displayed only if the value is something other than OK) – When a

negative Service State value is displayed, check for alarms and see alarm details

for the probable cause and suggested repair actions.

•

Power State

•

Device State

OSM actions allow you to power on or off a 4PSE, turn the LED on or off, and the

Replace action launches a documented service procedure to guide you through

replacement.

Recovery Operations for I/O Adapters and

Modules

•

Examine the contents of the event message log for the subsystem. For example,

the ServerNet LAN Systems Access (SLSA) subsystem or Storage subsystem

might have issued an event message that provides information about the resource

failure. Event messages returned by the SLSA and Storage subsystems are

described in the SLSA and STO sections of the Operator Messages Manual,

respectively.

•

HP provides a comprehensive library of troubleshooting guides for the

communications subsystems. Attempt to analyze the problems and restart the

process or object using the commands described in the appropriate manual listed

in Related Reading on page 8-8. If you are unable to start a required process or

object, contact your service provider.

Enabled State: Off The component is not functional.

Enabled State: On The component is functional.

Enabled State:

Unknown

State is unknown; component might not be responding.

Table 8-2. Service, Device, and Enabled States for the G4SA (page 2 of 2)

State Description

HP NonStop NS-series User Manual

Questions and Answers: