Processors and Components: Monitoring and
Recovery
HP Integrity NonStop NS-Series Operations Guide—529869-005
9-13
Reloading a Single Processor on a Running Server
*
specifies that all failed processors should be reloaded.
8. Check the OutsideView window for status messages, which will report successes
or errors during the load. Monitor the state of the processor you are loading until it
is executing the NonStop Kernel operating system.
9. If the load fails, check the parameters and reload the processor. If the load fails
again, contact your service provider.
Using the OSM Service Connection to Perform Reload
The OSM Service Connection provides a Reload action on the Logical Processor
object. You can perform the action on a single or multiple processors. The OSM action
lets you reload an entire processor or omit a Blade Element from the reload action so
you can dump the PE for that Blade Element before reintegrating it into the running
processor.
•
To reload a single processor:
1. Select the Logical Processor object for the processor you want to reload.
2. Right-click and select Actions.
3. Select Reload, click Perform action.
4. Click OK to the dismiss the confirmation dialog box.
5. In the Logical Processor Reload Parameters dialog box, select the appropriate
options. See OSM online help for information about the options.
6. Click OK.
To Next Page
Loading...
Need help?
General