Communications Subsystems: Monitoring and
Recovery
HP Integrity NonStop NS-Series Operations Guide—529869-005
6-11
Monitoring Line-Handler Process Status
This listing shows that the Expand line-handler process being monitored is up and
functioning normally.
The data shown in the report means:
If any state other than STARTED appears, check the meaning of the state in SCF
Object States on page 3-14. Depending upon the type of problem, follow your
established procedures for problem reporting and escalation.
Examples
To check the detailed status of line $LHCS6S:
> SCF STATUS LINE $LHCS6S, DETAIL
A listing such as this output is sent to your home terminal:
To display the status of all the Expand lines that are currently active on your system,
enter this INFO PROCESS command for the Expand manager process $NCP:
-> INFO PROCESS $NCP, LINESET
Name Specifies the name of the object
State Indicates the summary state of the object, which is either
STARTED, STARTING, DIAGNOSING (for SWAN concentrators
only), or STOPPED
PPID Specifies the primary process ID
BPID Specifies the backup process ID
ConMgr-LDEV Contains the LDEV of the concentrator manager process. This
field applies only to SWAN concentrator lines.
-> STATUS LINE $LHCS6S, DETAIL
PPID.................... ( 3, 24) BPID................ ( 2, 24)
State................... STOPPED Path LDEV........... 50
Trace Status............ OFF Clip Status......... UNLOADED
ConMgr-LDEV............. 49
Path-prim
Path-alter
To Next Page
Loading...
Need help?
General