4-22
Web and MAC Authentication
Configuring Web Authentication
Syntax: [no] aaa port-access web-based <port-list>
Enables web-based authentication on the specified
ports. Use the no form of the command to disable web-
based authentication on the specified ports.
Syntax: aaa port-access web-based <port-list> [auth-vid <vid>]]
no aaa port-access web-based <port-list> [auth-vid]
Specifies the VLAN to use for an authorized client. The
Radius server can override the value (accept-response
includes a vid). If auth-vid is 0, no VLAN changes occur
unless the RADIUS server supplies one.
Use the no form of the command to set the auth-vid to 0.
(Default: 0).
Syntax: aaa port-access web-based [clear-statistics]
Clears (resets to 0) all counters used to monitor the
CEI, HTTP, Web-Auth control traffic generated in web
authentication session. (To display Web-Auth traffic
statistics, enter the show port-access web-based statis-
tics command.)
Syntax: aaa port-access web-based <port-list > [client-limit <1-256>]
Specifies the maximum number of authenticated cli-
ents to allow on the port. (Default: 1)
Note: On switches where Web Auth and 802.1X can
operate concurrently, this limit includes the total num-
ber of clients authenticated through both methods. The
limit of 256 clients only applies when there are fewer
than 16,384 authentication clients on the entire
switch. After the limit of 16, 384 clients is reached, no
additional authentication clients are allowed on any
port for any method.
To Next Page
Loading...
Need help?
General