Hardware options installation 101
11.
Install the TPM security rivet by pressing the rivet firmly into the system board.
12. Install the fan cage.
13. Install the air baffle.
14. If removed, install the BBWC battery pack or the FBWC capacitor pack ("Installing the BBWC battery
pack or the FBWC capacitor pack" on page 86).
15. Install fan 5.
16. Install the access panel.
17. Do one of the following:
o Close or install the tower bezel, as needed.
o Install the server in the rack.
18. Power up the server (on page 22, "Powering up and configuring the server" on page 40).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
• Always store the recovery key/password in multiple locations.
• Always store copies of the recovery key/password away from the server.
• Do not save the recovery key/password on the encrypted hard drive.
Enabling the Trusted Platform Module
1. When prompted during the start-up sequence, access RBSU by pressing the F9 key.
2. From the Main Menu, select Server Security.
To Next Page
Loading...
Need help?
General
