11-2
Servers
Monitor Servers
Table 11-1. Monitored Server Fields
■ Click Apply to save the method used to add the server (Manually or Select from Discovered
List).
Select Server from Discovered List
Use the Add Server drop-down list on the Monitor Servers page to select this option and display a list
of discovered servers from which you can select the iLO enabled servers you wish to monitor. The
switch attempts to reach iLO enabled servers using SSDP discovery protocol. A maximum of 100
recently discovered servers can be listed. The discovered servers list is cleared following a reboot.
Note Server must be running iLo4 v1.3 or above for auto-discovery to function.
Figure 11-2. Discovered Servers Options
Field Description
Monitored Servers
Server: System Health System health indicator for monitored server.
OK—System is fully operational.
Degraded—System is operating at a reduced capacity.
Failed—One or more components are not operational.
Not Available—System status cannot be ascertained.
Server Product Name Monitored server name. A maximum of ten servers can be monitored.
Server: iLO IP Address IP address of the monitored server. Click the IP address to connect to the server. If the iLO IP
address has changed, an alert icon ( ) is displayed. Click the icon to update the link and
display the new IP address.
Delete Select to mark a server for deletion. Click Apply to delete the marked server.
Add New Server to Monitored List
Add Server Use the drop-down list to choose the method for adding a server to the monitored list
To Next Page
Loading...
Need help?
General
