HP ProLiant DL140 Server Setup and Installation Guide 44
B
Electrostatic Discharge
To prevent damaging the system, be aware of the precautions needed to follow when setting up
the system or handling parts. A discharge of static electricity from a finger or other conductor
may damage system boards or other static-sensitive devices. This type of damage may reduce the
life expectancy of the device.
Preventing Electrostatic Damage
To prevent electrostatic damage:
• Avoid hand contact by transporting and storing products in static-safe containers.
• Keep electrostatic-sensitive parts in their containers until they arrive at static-free
workstations.
• Place parts on a grounded surface before removing them from their containers.
• Avoid touching pins, leads, or circuitry.
• Always be properly grounded when touching a static-sensitive component or assembly.
Grounding Methods
There are several methods for grounding. Use one or more of the following methods when
handling or installing electrostatic-sensitive parts:
• Use a wrist strap connected by a ground cord to a grounded workstation or computer chassis.
Wrist straps are flexible straps with a minimum of 1 megaohm ± 10 percent resistance in the
ground cords. To provide proper grounding, wear the strap snug against the skin.
• Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on both
feet when standing on conductive floors or dissipating floor mats.
• Use conductive field service tools
• Use a portable field service kit with a folding static-dissipating work mat
If the suggested equipment for proper grounding is not available, have an authorized reseller
install the part.
NOTE: For more information on static electricity or for assistance with product installation,
contact an authorized reseller.
To Next Page
Loading...
Need help?
General