HP ProLiant DL140 Server Setup and Installation Guide 54
Table D-2: System Configuration Switch (SW1) Settings
Position Function Default Description
S1 PASSWORD CLEAR OFF ON = PASSWORD CLEAR
OFF = NORMAL
S2 CMOS CLEAR OFF ON = CMOS CLEAR
OFF = NORMAL
S3 RECOVERY MODE OFF ON = RECOVERY MODE
OFF = NORMAL
S4 CONFIG LOCK OFF ON = CONFIG LOCK
OFF = NORMAL
NOTE: “On” activates the function.
Clearing and Resetting System Password Settings
It may be necessary at some time to clear and reset the system password.
IMPORTANT: This method of clearing and resetting system passwords is only necessary if
the current password is not known.
Otherwise, when prompted, the password can be entered followed by a forward slash (/). This
operation removes the current password and allows one of the following to be performed:
• Enter BIOS Setup and set the password to a new value.
• Leave the password value blank to disable the password feature.
When the system switch position 1 is set to the ON position, the system is prepared to clear the
system password.
1. Power down the server.
2. Set the switch at position 1 to the ON position.
3. Restart the server, and wait for confirmation.
4. Power down the server.
5. Set the switch at position 1 to the default OFF position.
6. Restart the server. The password is cleared.
Clearing and Resetting System Configuration Settings
It may be necessary at some time to clear and reset system configuration settings. When the
system switch position 2 is set to the ON position, the system is prepared to erase all system
configuration settings from both CMOS and NVRAM.
IMPORTANT: Clearing CMOS and/or (NVRAM) deletes the configuration information. Refer
to Chapter 5 for complete instructions on configuring the server.
To Next Page
Loading...
Need help?
General