To Next Page

To Previous Page

User’s Guide 3–1

Setting Up the Monitor

Unpacking the Monitor

1. Unpack the monitor. Make sure all contents are included. Store the packing box.

2. Turn off the computer and other attached devices.

3. Determine whether the monitor will be desktop mounted or wall-mounted. See “Installing the Monitor.”

4. Prepare a flat area to assemble the monitor. You may need a flat, soft, protected area for placing the monitor

screen-down while preparing it for installation.

5. You need a Phillips screwdriver for preparing the monitor for wall-mounting. You may need a straight-slot

screwdriver to secure some cables.

Installing the Monitor

You can install the monitor on a desktop or wall-mount it. Place the monitor in a convenient, well-ventilated location

near your computer.

If the monitor will be installed on a:

■ Desktop or table, see “Installing on a Desktop.”

■ Wall, swing arm, or other mounting fixture, see “Wall-Mounting the Monitor (Mounting Fixture not Supplied).”

Connect the monitor cables after you have installed the monitor.

Installing on a Desktop

Follow the instructions for your monitor type.

Questions and Answers:

Need help?

Do you have a question about the HP w2207 and is the answer not in the manual?

HP w2207 Specifications

General

Plug and Play	Yes
Height adjustment	No
Cable lock slot type	Kensington
Panel mounting interface	100 x 100 mm
Display diagonal	22 \
Display resolution	1680 x 1050 pixels
Contrast ratio (dynamic)	-
Contrast ratio (typical)	1000:1
Viewing angle, horizontal	160 °
Digital vertical frequency	48 - 76 Hz
Digital horizontal frequency	24 - 82 kHz
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1680 x 1050 (WSXGA+)
Power consumption (standby)	2 W
Power consumption (typical)	65 W
Storage temperature (T-T)	20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
DVI-I ports quantity	0
RMS rated power	4 W
Number of speakers	2
Product color	Black
Country of origin	China