CAUTION
Before inserting the disk, release the disk handle to the maximum angle; otherwise, the disk
cannot be fully inserted into the empty slot.
Step 8 As shown in step ① in Figure 6-4, insert the disk module into the empty slot.
Step 9 As shown in step ② in Figure 6-4, close the handle.
When the disk starts, the disk running indicator blinks. It indicates that data is being transmitted
to the new disk.
NOTE
According to the configurations, the storage system can automatically reconstruct data to the new disk.
Figure 6-4 Install a disk module
1
2
Step 10 According to the status of the disk running indicator and the alarm indicator, judge whether the
disk module is successfully installed.
l If the disk running indicator is on and the alarm indicator is off, it indicates that the disk
module is successfully installed.
l If the disk alarm indicator is on, it indicates that the disk module may be wrongly installed.
Remove the disk module and insert it again. If the disks alarm indicator is on after the
installation, it indicates that the disk module that is installed just now is faulty. Replace the
disk module with a new one.
Step 11 Wait for one minute and then log in to the ISM. Choose the Physical View tab. In the navigation
tree, choose Controller Enclosure to view whether the status of each component is normal.
l Yes: The installation is complete. On the menu bar, choose Alarm > Alarm
Management… to go to the Alarm Management interface. On the Current Alarm tab,
choose Recovery Time. The time for recovering the alarm is displayed.
OceanStor S2600 Storage System
Troubleshooting 6 Replacing Parts
Issue 03 (2010-01-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-7
To Next Page
Loading...
Need help?
General