GENESIS OPERATIONS MANUAL
12
4. SET START TIME FOR A PROGRAM
Puts the controller in the proper mode for changing the Program setting. The display shows:
Program. . . 1
The cursor is under the Program number. If you press PROGRA
M again, the number advances. Continue
pressing PROGRAM until the number showing is the Program you want to change, or press a number key from 1
to 5.
When you press GROUP START TIMES (key on some models will say only START TIMES, function
is identical
), the display shows:
P2 T1 = <off>
The P2 in this example indicates the second Program, and the T1 indicates the first Start. The word <off> means
there is no programmed Start time yet.
Press the number keys for the Start time you want (the example s
hows 3:45).
As you enter numbers, the display changes to zeros and each new number
moves previous ones to the left.
Changes the time to PM. (Controller assumes AM.) Press AM/PM/? repeatedly to toggle between
AM and PM.
Accepts the Start time setti
ng.
Press START TIME again, the
display shows:
P2 T1E = <off>
The E in this display prompts for an optional End time. If you enter an End time, the controller will stop the
watering cycle at that time
--
no matter how many minutes of Run Time remain
.
To enter an End time, press the number keys, PM, and ENTER as you did to enter the Start time. Or, to skip the
End time, press START TIME again to set up another Start time.
The End time feature protects you from unintentionally irrigating at the wron
g time. It's useful if you're using
continuous cycling during certain hours, or if customers begin to show up at certain times. To remove a Start or
End time, press CLEAR; the display will change to zeroes. Press ENTER, and the display will change to <o
ff>.
To continue programming Run Times, select the Start you want to work with, press RUN TIME, and continue with
Step #5 (SET RUN TIME).
Exits the function, restores the time display.
To Next Page
Loading...
Need help?
General
