To Next Page

To Previous Page

GENESIS OPERATIONS MANUAL

Completes the removal of Programs from memory. The display shows:

Cold Start!

This message shows in the display, alternating with the time in hours and minutes.

If the default Program is loaded by Option 12, Cold Start returns all programming to the default setting: Ten

minutes Run Time per station, at 10 PM every day, for Program 1, Start 1 only.

Press CLEAR to remo

ve the Cold Start message. The display shows the time in hours, minutes, and

seconds.

Maintenance Radio Operations

NOTE: This section pertains to

radio

equipped

Genesis series controllers only. If your controller is hard

wired and

uses Maintenance Radio

through the central interface (at the computer), please refer to the manual for your central

interface for maintenance radio instructions.

Genesis Maintenance Radio is a valuable tool that allows remote control of your irrigation controller by means of a

UHF hand

held transceiver

directly to any Genesis Radio series controller.

With the Genesis Maintenance Radio, you can:

Manually control any valve of any Field Controller (FC) in your system.

Semi

Auto start a Program/start of any FC, even on a part

icular station

Perform timed syringe cycles on up to six valves simultaneously in either HH:MM or MM:SS mode.

Sequentially step

up/step

down valves on a Field Controller.

All Genesis Radio field controllers have the ability to respond directly to a UHF

handheld radio transceiver (on the

correct frequency) equipped with a DTMF (dual tone, multi

frequency, or TouchTone

) key pad.

Genesis Radio controllers do NOT require the central computer system to communicate with Maintenance Radio

transceivers.

Hunter Genesis User Manual

Questions and Answers: