To Next Page

To Previous Page

GENESIS OPERATIONS MANUAL

Option #5

Cycles

You can use this optio

n to set all the stations in a certain Program/start to repeat their cycles. For example, this

option allows you to run a group of stations several times a day to keep a newly seeded area moist.

Select the Program/Start you want to set repeating cycles

for. Then, when you select option #5, the display

shows:

P1 T1 Cycles <1>

Number 1 indicates normal programmed operation. You can enter any number up to 9, but be aware that if you

enter a zero, the stations in that Program/start will repeat contin

uously until stopped by a programmed End time, a

programmed skip day, or a manual OFF.

Press the number key for the number of repetitions you want. In this example, the display shows the

cycle will repeat five times:

P1 T1 Cycles= 5

Completes th

e option setting. The display shows:

P1 T1 Cycles= 5

Exits the function, restores the time display.

Option #6

Cycle Delay

This option sets the length of time between repetitions, or cycles, in a cycle Program (see Option #5).

Select the Pr

ogram and Start you want to set the cycle delay for. Then, when you select option #6, the display

shows:

Cycle Dly <off>

The maximum delay time you can Program is 24 hours.

Press the number keys for the length of time you want between repetitions of

the watering

cycle. In this example, the display shows a 30

minute delay from the end of one cycle to

the beginning of another:

Cycle Dly 0:30M

Note: The time mode (M or S) is dependent on the setting of Option #3. To change modes, see Option #3.

ompletes the option setting. The display shows:

Cycle Dly= 0:30M

Hunter Genesis User Manual

Questions and Answers: