GENESIS OPERATIONS MANUAL
14
HOW TO OPERATE THE CONTROLLER
The following directions explain some of the most common tasks you may want the controller to perform. The
symbols at the left of the page show you the correct order for pressing th
e keys. The explanations at the right tell
you what happens as you go through the steps.
1. START A SEMI
-
AUTOMATIC RUN AT A PARTICULAR
PROGRAM/START AND STATION
A semi
-
automatic start causes one (or more) of your timed automatic Program Starts to
run immediately. First
select a Program, then a Start within the Program, and (if you like) a station within that Program Start on which to
begin.
When you press PROGRAM, the display shows:
Program. . . 1
The cursor is at the Program number. If you
press PROGRAM (GROUP, in some models) again, the
number advances. Continue pressing PROGRAM until the Program number you want to run is
displayed, or press a number key from 1 to 5.
If you press SEMI AUTO now, the controller assumes Start #1, Stati
on #1.
The display will show the Program number, Start number, and actual Start time. For example:
P2 T1 = 03:45 PM
If you want to semi
-
auto start a different Start within the Program, continue to press START TIME until
the number showing is the Star
t you want. The semi
-
auto cycle begins at the first station of that Start.
Note: If you don't want the semi
-
auto cycle to begin at the first station of that Start, you can choose a different
one. Press RUN TIME until the number showing is the station
you want.
Selects semi
-
auto operation and asks you to confirm the Program/start you have specified.
Accepts and completes the semi
-
automatic setting. All remaining stations will start and run
sequentially within that Program.
Note: After you pr
ess ENTER to complete the semi
-
auto function, you may advance to the next station with a Run
Time by pressing SEMI
-
AUTO.
Exits the function, restores the time display.
To Next Page
Loading...
Need help?
General
