To Next Page

To Previous Page

APPENDIX C – BEVEL CUTTING

c-10 HPR130 Manual Gas Instruction Manual

Part selection

Note: Standard consumables can be used for bevel cutting, but are not optimized for bevel cutting.

Water tube 220571 or 220700 must be installed in the HPR torch when using consumables specifically designed for

bevel cutting. The bevel quick-disconnect with the short torch-mounting sleeve has push-to-connect fittings and must be

used with the specific lead sets listed in this section.

Torch 220162

Used in all applications

Bevel quick-disconnect 220573

short torch-mounting sleeve

(included in 220573)

Torch sleeve: standard

220232

Torch sleeve: extended

220516

Standard quick-disconnect 220163

Leads with push-to-connect fittings

and 1.83 m (6 ft) gas leads

Leads with push-to-connect fittings

and 2.5 m (8.17 ft) gas leads

Leads with standard fittings and

1.83 m (6 ft) gas leads

Leads with standard fittings and

2.5 m (8.17 ft) gas leads

Quick-disconnect assembly

Gas lead length

Overall lead length

See table 1

See table 2

Standard leads

to off-valve

fittings

To RHF console

Water tube 220571

(220700 for mild steel)

Bevel leads

to off-valve

fittings

Hypertherm HPR130 User Manual

Other manuals for Hypertherm HPR130