Changed
Page
Description of change for revision 6 (date of change - 4/2008)
5.28–5.34 Added new coolant flow troubleshooting onformation.
5.37 Changed the firmware part numbers from 081094 to 081107.
5.41
Added 50 amp information and updated information for other amperages in the pilot arc current table and
the transfer current table.
5.42 Changed the firmware part numbers from 081093 to 081109.
5.44
Added call-outs for pressure sensors (P1-P4) to the graphic at the top of the page. Added graphics with
call-outs for solenoid valves in the gas console and off-valve.
5.45 and 5.46 New chopper test.
5.54 and 5.55 Updated service parts replacement schedule.
6.2
Added the 220 volt power supply. The part number for sheet metal screws (item 3) has changed from
075630 to 075241. Added part numbers for sheet metal (front, top, and side panels).
6.4 and 6.13
Moved start circuit assembly from item 6 to item 5. Listed the 2 current sensors separately (6a and 6b) to
identify their designators. 108263 (item 7 – fuse) was a 150 amp fuse and is now 175 amps (6.13 also).
6.5
Added temperature sensor (item number 4 – 109393). Changed stand alone pump and motors to kits that
include the clamp. Added solenoid valve (item number 9 - 006046).
6.6 Added a page to list control transformers.
6.7 Added designator for HFHV ignition PCB.
6.11 Changed silicone lubricant part number from 027012 to 027055. Added spanner wrench (104269).
6.12 Added 50 amp consumables.
Wiring diagrams
Section 7
Added "Dipswitch setting example" to sheets 15, 16 and 17. Updated all sheets to revision "K".
Appendix A MSDS appendix changed from appendix B to appendix A.
Appendix B Software functional description changed from appendix A to appendix B.
Appendix C Added 130 amp bevel process information.
To Next Page
Loading...
Need help?
General
