Hypertherm MAXPRO200 User Manual

MAXPRO200 Instruction Manual 807700 Revision 1 101
Operation
Cut charts
The following cut charts for the MAXPRO200 show the consumable parts, cutting speeds, and the gas and torch
settings required for each process, allowing for differences in the lead length. While you can use these parameters for
cutting with both mechanized and handheld torches, the consumable part numbers listed with each cut chart are specific
to mechanized torches. Refer to Hand held cutting and gouging consumable selection on page 87 for the consumables
to use for handheld torches for each process.
The cut chart values in this document are recommended to provide high quality cuts with minimal dross. Because of
differences between installations and material composition, adjustments may be required to obtain desired results.

Hypertherm MAXPRO200 Specifications

General

Brand	Hypertherm
Model	MAXPRO200
Category	Welding System
Language	English