2-4
powermax600 Service Manual
S
PECIFICATIONS
S MARK (230/400 VOLT ONLY)
The S mark indicates that the power supply and torch are suitable for use in environments with increased
hazard of electrical shock. The hand torches must have shielded consumable parts to maintain S mark
compliance.
SETUP SPECIFICATIONS
Check Required Input Voltage
Look at U1 on the data plate to check input voltage requirements.
The data plate is on the back of the power supply. See Figure 2-4.
Figure 2-4 Data Plate Input Voltage
Install Power Cord Plug
Use a power cord plug that is certified by national or local
electrical codes. The plug should be connected to the
power cord by a licensed electrician.
10-99
To Next Page
Loading...
Need help?
General
