Directory
115
ODV Quality Wizard
Figure 94. ODV Quality Wizard Window
NOTE: You must set the following in the VALIDATOR menu to use the ODV
(Online Data Validator) Quality Wizard:
• Set Telemetry Path to Network Port.
• Set Telemetry Data to Full Report or Validation Mode.
The ODV Quality Wizard is a function that helps you select the best
combination of print speed and print intensity that will produce optimal bar
code output. It displays controls that allow you to select a print speed and a
print intensity.
Click the Test Print button to print and validate a test bar code pattern. Based
on the validation results, the ODV Quality Wizard provides setting
suggestions to optimize the bar code quality.
IMPORTANT
Do not follow any suggestions if “Barcode Code 39 Status” does not
display “Pass.”
Click OK to save these changes in Configuration 1. Configuration 1 then
becomes the Power-Up configuration (see page 67). Click Cancel to not save
the changes.
IMPORTANT
Clicking the Close button in the upper-right corner functions the
same as clicking OK.
NOTE: The ODV Quality Wizard is printer specific, and not all printer models
have ODV Quality Wizard support. Printers without ODV Quality
Wizard support display the error message:
Operation not allowed on this type of printer.
To Next Page
Loading...
Need help?
General
