6
- Press system power button if it sets to act as standby function.
- System is idle and the standby timer set in the Windows 98 Power Man-
agement Property elapses.
Power Supply
•
PC-98 compatible 145W ATX power supply
•
Searchable high/low voltage selection
Internal Cabling
•
Two 40-pin ribbon cables for hard disk drive and CD/DVD-ROM drive.
•
One 34-pin ribbon cable for AT diskette drive.
•
One 4-pin (2-wire) cable for hard disk drive light-emitting diode (LED).
•
One 3-pin (3-wire) cable for power light-emitting diode (LED).
•
One 2-pin (2-wire) cable for power switch.
•
One 4-pin modem voice-in/speaker-out cable.
•
56.6 Kbps PCI modem adapter card with data/fax/voice or non-voice
features.
•
Telephone line-out (RJ-11) connector.
•
Telephone line-in (RJ-11) connector.
Monitor (Not included with some models)
•
Super Video Graphics Array (SVGA) monitor.
•
Compliant to VESA power saving mode.
•
Connector for a detachable grounded 3-wire power cord
•
1.8-m (5.8-ft.) attached signal cable
•
Auto-sensing power input for 100 Vac to 240 Vac
•
15" (13.7" viewable image size) monitor
- 0.28-mm dot pitch
- Automatic scanning horizontal frequencies from 30 KHz to 54 KHz or 30
KHz to 69 KHz (for Japan)
- Vertical frequencies between 50 Hz and 120 Hz.
- DDC2A/B or DDC1/2B+ support (for Japan)
- OSD (On-Screen Display) menu (for Japan)
•
17" (15.7" viewable image size) monitor
- 0.28-mm or 0.27-mm dot pitch (for Japan)
- Automatic scanning horizontal frequencies from 30 KHz to 69 KHz or 30
To Next Page
Loading...
Need help?
General