Find the unit reference code in the following table. If the failing item is a disk unit,
go to Start Disk Service.
Attention: The 673x is a read cache. Perform all actions required for 673x as a
disk drive and logic card except where separate 673x cache instructions are
provided.
For more on the Failing Item column entries, see Table 2. Disk Unit Failing Items
Details, which follows the reference code table below.
Table 1. (432x, 660x, 671x, 673x) Disk Unit Reference Codes
Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
102E Out of alternate sectors for disk storage DISKDRV
3002 Addressed device failed to respond to selection DISKDRV
STORIOA
BACKPLN
FI01106
FI01140
3010 Disk device returned wrong response to IOP DISKDRV
STORIOA
FI01140
FI01141
3020 Storage subsystem configuration error
If an MES is being installed, verify the configuration.
DISKDRV
FI01106
STORIOA
FI01140
3029 A device replacement has occurred
No action required. This reference code is logged for information only.
3100 Tape/CD or disk bus interface error occurred
Perform DU-PIP3.
DISKDRV
STORIOA
FI01106
FI01140
3109 IOP timed out a disk command DISKDRV
STORIOA
FI01106
FI01140
3110 Disk bus interface error occurred
Perform DU-PIP3.
STORIOA
DISKDRV
FI01106
FI01140
3130 Device Licensed Internal Code
The device is not supported with the level of code currently on the system.
Contact your next level of support.
SVCDOCS
3131 Device or IOA Licensed Internal Code
The device does not support a needed attribute and is running with
degraded performance. Contact your next level of support.
SVCDOCS
7000 Disk sector read error
No action required. This reference code is logged for information only.
DISKDRV
432x, 660x, 671x, 673x
172
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
To Next Page
Loading...
Need help?
General