IBM iSeries 800 Hardware Problem Analysis And Isolation

5. Search the entries on the Log Analysis Report display for system reference codes associated with the
missing disk units.
6. Go to System Reference Codes and use the SRC information to correct the problem.
This ends the procedure.
0024:
The system type or system unique ID needs to be entered.
1. Select Manual mode and perform an IPL to DST (see Performing an IPL to DST in the iSeries
(TM)
Service Functions information).
2. When prompted, enter the correct system type or system unique ID.
This
ends the procedure.
0025:
Hardware Resource Information Persistence disabled.
1. Select Manual mode and perform an IPL to DST (see Performing an IPL to DST in the iSeries
(TM)
Service Functions information).
2. Contact your next level of support for instructions on how to enable the Hardware Resource
Information Persistence function.
This ends the procedure.
0026:
A disk unit is incorrectly configured for an LPAR system.
1. Select Manual mode and perform an IPL to DST (see Performing an IPL to DST in the iSeries
(TM)
Service Functions information).
2. On the Service Tools display, select Start a Service Tool—>Product activity log—>Analyze log—>.
3. On the Select Subsystem Data display, select the option to view All Logs.
Note: You can change the From: and To : Dates and Times from the 24-hour default if the time that the
customer reported having the problem was more than 24 hours ago.
4. Use the defaults on the Select Analysis Report Options display by pressing Enter.
5. Search the entries on the Log Analysis Report display for system reference codes (B6xx 53xx) that are
associated with the error.
6. Go to System Reference Codes and use the SRC information to correct the problem.
This ends the procedure.
0031:
A problem was detected with the installation of Licensed Internal Code service displays. The cause
may be defective media, the installation media being removed too early, a device problem or a Licensed
Internal Code problem.
v Ask your next level of support for assistance. Characters 13-16 of the top 16 character line of function
12 (4 rightmost characters of word 3) contain information regarding the install error.
v For more information about the install error, see the ″LIC Install Debug Information″ chapter in the
iSeries
(TM)
Licensed Internal Code Diagnostic Aids - Volume 1.
v If the customer does not require the service displays to be in the national language, you may be able to
continue by performing another system IPL.
This
ends the procedure.
0033:
System model not supported.
This model of hardware does not support the System Licensed Internal Code version and release that is
being used. Use a supported version and release of the System Licensed Internal Code.
This ends the procedure.
0034: Insufficient main storage capacity.
Analyze hardware problems 133

IBM iSeries 800 Specifications

General

Brand	IBM
Model	iSeries 800
Category	Server
Language	English