LOC_SYS
For use by authorized service providers.
A problem has occurred on the local (this) system with HSL OptiConnect. The Service Action Log (SAL)
code will attempt to identify the HSL loop number as a portion of the part description for this symbolic
FRU. Search the SAL of this system for hardware and LIC problems. Correct any problems that you find
with LIC or Network Interface Controller (NIC) hardware.
LPARCFG
For use by authorized service providers.
There is a configuration problem with a logical partition. Perform any actions listed in the
″Description/Action″ column in the Unit Reference Code Table for the SRC.
Have the customer check processor and memory allocations to the secondary partitions. The customer
must ensure that there are enough functioning processor and memory resources in the system for all the
partitions. Be aware that processor or memory resources that failed during system IPL could have caused
the IPL problem in the secondary partition.
Have the customer check the bus and I/O processor allocations for the secondary partition. The customer
must ensure that the partition has load source and console I/O resources.
Have the customer check the IPL mode of the Primary partition and the failing secondary partition:
v If the Primary partition is IPL’d in mode ’C’ then secondary partitions can only be IPL’d in mode ’C’. If
that is the problem, then re-IPL the Primary partition in either ’A’ or ’B’ mode. Then the secondary
partition can IPL in any mode.
v If the Primary partition is IPL’d in mode ’C’ then ″Guest″ partitions will not IPL.
For ″Guest″ partitions, this may be a problem accessing or loading the specified Kernel.
For further assistance the customer should contact their software service provider, or visit the IBM web
page at http://www.ibm.com/servers/eserver/iseries/lpar/ for additional support direction.
LPARSUP
For use by authorized service providers.
There is either an IPL problem, MSD problem, or a software error with a secondary partition. Perform any
actions listed in the ″Description/Action″ column in the System Reference Code Table for the SRC.
During the IPL or mainstore dump of a secondary partition, a complex problem was detected. The Primary
partition’s SAL has to be searched or the SRC history list in the primary partition for the secondary
partition with the problem has to be analyzed in sequence. If the secondary partition is a ″Guest″ partition,
then the SRC history list of the ″Hosting″ partition must be analyzed.
Contact your next level of hardware support.
LSMEDIA
For use by authorized service providers.
The load-source media is the failing item.
v If the load-source is tape, exchange the tape in the alternate IPL tape unit. If replacing the media does
not work, try replacing the tape device unit.
v If the load-source is an optical storage unit, exchange the compact disk. If replacing the media does not
work, try replacing the optical storage device unit.
360 iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis and
Isolation
To Next Page
Loading...
Need help?
General