3. Lower the vacuum pen tool onto the system processor module to install. Fully press the top of the
pen (A) and hold the pen in the center of the system processor module as shown in Figure 53. Release
the top of the pen to fasten the pen onto the system processor module.
Note: To prevent the system processor module from falling, do not press the tip while holding the
pen and the system processor module. Minimize the time and distance that you have the pen holding
the system processor module, in case the vacuum seal releases early.
4. Install the system processor module:
a. Lower the pen and system processor module onto the socket as shown in Figure 54 on page 52.
Align the beveled corner of the system processor module with the beveled corner on the system
processor socket. Use care to lower the tool evenly without tilting the system processor module.
Note: Do not attempt to slide the tool and the system processor module in any direction while the
system processor module is touching the system processor socket.
Figure 53. Lowering the removal tool onto the system processor module
Removing and replacing parts in the 7063-CR1 51
To Next Page
Loading...
Need help?
General