6. Move the load arm (A) into position over the heat sink (B) and tighten the load arm screw with a #3
Phillips screw driver, as shown in Figure 56.
Note: Do not overtighten the load arm screw.
7. Install the system processor air baffle as shown in Figure 57 on page 54. Insert the edge of the system
processor air baffle into the fan support. Then, carefully press the system processor air baffle down
into place.
Figure 56. Tightening the load arm screw
Removing and replacing parts in the 7063-CR1 53
To Next Page
Loading...
Need help?
General