Internal cable routing
Attention: Failing to install or remove the cable with care may damage the
connectors on the system board. Any damage to the connectors may require
replacing the system board.
Hot-swap hard disk drive backplane cable connections
This section provides information about routing the cables when you install some
components in the server.
For more information about the requirements for cables and connecting devices,
see the documentation that comes with these devices.
Note: When the hot-swap backplane is in use, make sure that Port 1 on the
hardware ServeRAID or system board is connected to Port 1 on the backplane.
Likewise, Port 0 on the hardware ServeRAID or system board should be connected
to Port 0 on the backplane.
The following illustration shows the hardware ServeRAID cabling information for
twelve 3.5-inch hot-swap drive backplane assemblies:
The following illustrations show the cabling information for the power paddle
card:
164 System x3650 M4 BD Type 5466: Installation and Service Guide
To Next Page
Loading...
Need help?
General