Replacing a RAID adapter battery or flash power module in the
RAID battery tray
Use this information to replace a RAID adapter battery or flash power module in
the RAID battery tray.
About this task
When you install any ServeRAID adapter in the server that come with a RAID
adapter battery, the battery must be installed remotely to prevent the battery from
overheating.
To install a RAID adapter battery in the RAID battery tray, complete the following
steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 32.
2. Slightly use your finger or thumb to unlock the battery retention clip from the
battery holder. During the unlocking process you will hear a "click" sound.
3. Install the battery in the RAID battery tray:
a. Orient the battery as shown in the following illustration; then, lower the
battery into the RAID battery tray. If the battery comes with a battery
carrier, ensure that battery carrier posts align with the rings on the battery
mounting slot so that the battery carrier is secure in the slot.
b. Push the battery retention clip back to its vertical position until it snaps into
place, thereby securing the battery.
4. Connect the remote battery cable to the remote battery cable connector to the
ServeRAID adapter. Route the remote battery cable in the server as shown in
Figure 108. RAID adapter battery installation
196 System x3650 M4 BD Type 5466: Installation and Service Guide
To Next Page
Loading...
Need help?
General