IBM System x3650 M4 BD Type 5466 User Manual

10. Disconnect the cable to the front USB connector assembly.
11. If you are instructed to return the front USB connector assembly cable, follow
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Replacing the front USB connector assembly cable
Use this information to replace the front USB connector assembly cable.
About this task
To install the front USB connector assembly cable that is on this side of the server,
complete the following steps:
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 32
2. Connect the front USB connector assembly cable to the system board and
route the internal cabling as shown in the following illustration.
Attention: Make sure the relevant cables pass through the cable clips.
Figure 126. Front USB connector assembly removal
216 System x3650 M4 BD Type 5466: Installation and Service Guide

IBM System x3650 M4 BD Type 5466 Specifications

General

Brand	IBM
Model	System x3650 M4 BD Type 5466
Category	Server
Language	English