4. Reconnect the cables between the upper power supply card and lower
power-supply paddle card.
5. Align the screw holes on the safety cover (240VA cover) with the screw holes
on the chassis; then install the screws.
6. Install the screws to secure the safety cover.
7. Install the server top cover (see “Replacing the server top cover” on page 260).
8. Install the power supplies.
9. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Figure 135. Upper power supply card installation
Figure 136. safety cover installation
Chapter 6. Removing and replacing components 223
To Next Page
Loading...
Need help?
General