v Leader pin attach tool (see ▌1▐ in Figure 38). A plastic brace that holds the
cartridge door open.
v Cartridge manual rewind tool (see ▌2▐ in Figure 38). A device that fits into the
cartridge's hub and lets you wind the tape into and out of the cartridge.
v Pin supplies (see ▌3▐ in Figure 38). Leader pins and C-clips.
Attention:
v Use only the IBM Leader Pin Reattachment Kit to reattach the leader pin to the
tape. Other methods of reattaching the pin will damage the tape, the drive, or
both.
v Use this procedure on your tape cartridge only when the leader pin detaches
from the magnetic tape and you must copy the cartridge's data onto another
cartridge. Destroy the damaged cartridge after you copy the data. This
procedure may affect the performance of the leader pin during threading and
unloading operations.
v Touch only the end of the tape. Touching the tape in an area other than the end
can damage the tape's surface or edges, which may interfere with read or write
reliability.
Procedure
To reattach a leader pin by using the IBM Leader Pin Reattachment Kit, perform
the following steps:
1. Attach the leader pin attach tool (▌1▐ in Figure 39 on page 130) to the
cartridge ▌2▐ so that the tool's hook ▌3▐ latches into the cartridge's door ▌4▐.
Pull the tool back to hold the door open, then slide the tool onto the cartridge.
Open the tool's pivot arm ▌5▐.
Figure 38. Leader Pin Reattachment Kit
Chapter 2. Planning 129
To Next Page
Loading...
Need help?
General