Icom IC-M504 Instruction Manual

15
6
DSC OPERATION
5
6
■ MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC
self ID) code can be programmed at power ON.
This code programming can be performed only twice.
After the code programming, it can be changed only by
your dealer or distributor.
q Turn power OFF.
w While pushing [MENU], turn power ON to enter MMSI
code programming condition.
e After the display appears, release [MENU].
r Push [MENU] again to enter the DSC menu.
t Rotate [DIAL] to select “Set up,” push [DIAL•ENTER].
y
Rotate [DIAL] to select “MMSI Check,” push [DIAL•ENTER].
u Rotate [DIAL] to set the specific 9-digit MMSI code.
 •Push[16•9] or [CH/WX•DUAL•U/I/C] to move the cursor for-
ward or backward, respectively.
 •Push[CLR] to cancel and return to the set up menu.
i After entering the 9-digit code, push [DIAL•ENTER] to set
the code.
 •Returnstothesetupmenu.
o Push [CLR] or rotate [DIAL] to select “Exit,” push
[DIAL•ENTER].
 •ReturnstotheDSCmenu.
 •Repeatagaintoreturntothenormaloperationcondition.
--DSC Menu--
Select Item
Position Input
Received Calls
˘Set up
Exit
--DSC Menu--
Set up
Add:INDV ID
Add:Group ID
DEL:INDV ID
DEL:Group ID
Offset Time
˘MMSI Check
--DSC Menu--
MMSI Check
_________
<CLR˘Exit / ENT˘OK>

Icom IC-M504 Specifications

General

Brand	Icom
Model	IC-M504
Category	Transceiver
Language	English