17
5
SCAN OPERATION
■ Setting Favorite channels
You can quickly recall often-used channels by setting them as Favorite channels. You can
set Favorite channels in each Channel Group.
1. Select a Channel Group on the Menu screen. (p. 10)
[MENU] > Settings > Radio > Channel Group
2. Push [▲] or [▼], or rotate [CH/ENT] to select the channel.
3. Push [◄] or [►] to display
.
4. Push
.
• The selected channel is set as a Favorite channel, and “ ” is displayed.
L To cancel the setting, push
again.
TIP: You can set all channels as Favorite channels, clear all settings, or reset to the
defaults. By default, some channels are preset as Favorite channels. The preset
channels diff er, depending on the transceiver version.
■ Starting a scan (Except for the NLD version)
Example: Starting a Normal Scan.
1. Select a Channel Group on the Menu screen. (p. 10)
[MENU] > Settings > Radio > Channel Group
2. Push [◄] or [►] to display
.
3. Push
.
• The scan starts.
• “SCAN” is displayed during a Normal Scan, and
“SCAN 16” is displayed during a Priority Scan.
• “SCAN” and “ ” are displayed when a signal is
received.
L When a signal is received, the scan pauses until it
disappears, or resumes after 5 seconds, depending
on the Scan Timer setting in “Radio Settings.”
L A beep sounds and “16” blinks when a signal is
received on Channel 16 during a Priority scan.
4. To stop the scan, push
.
TIP: To properly receive signals, be sure to adjust the
squelch to a suitable level.
To Next Page
Loading...
Need help?
General
