67
9
■ Navigation
The transceiver assists you to navigate to a selected destination.
L The function works only when the transceiver is receiving valid GPS signals.
L The function cannot work while in the MOB mode.
NOTE: The Navigation function is a supplemental aid to navigation only, and is not
intended to be a substitute for primary navigation equipment.
Using [NAV]:
1. Push
on the operating screen.
• The “Waypoint” screen is displayed.
2.
waypoint.
3. Push
to start navigation.
• The plotter screen is displayed, and the transceiver
starts to navigate.
•
is displayed on the plotter screen.
4. Push the Software Key for your next operation.
D Starting navigation
There are 3 ways of setting a destination using
selecting in the Waypoint list.
NOTE: A popup screen is displayed when the vessel arrives at or near the destination.
To stop the function, push any key.
L When the Audible Alarm function is set to “ON,” an alarm also sounds. (p. 60)
Navigating to a waypoint:
See “Navigating to a waypoint” on page 64 for details.
To Next Page
Loading...
Need help?
General
