Icom rs-ba1 User Manual

A-1
RS-BA1
Installation guide A
RS-BA1
Installation guide A
Form2001
This guide explains the minimum required settings to congure a remote control system, taking the following
illustration as an example. In this example, a radio is connected to the Base station’s PC with the supplied USB
cable, and a remote station remotely controls the radio through the network.
• We recommend that you place the Remote station’s PC near to the Base station's PC and a radio, to check that
the settings are correct, and that you can correctly control the radio.
• You need to register the ID and password to the Base station to enable the Remote station to access the Base
station and the radio. BE CAREFUL in managing IDs and passwords.
• See the Instruction Manual, for detailed instructions on the RS-BA1.
You can also refer to each software’s help le, for assistance with the functions and settings.
While the software is open, push the [F1] key of the PC’s keyboard to open the help le.
Example of the remote control system
* In this illustration, routers or other devices are not described.
RC-28
(Optional)
InternetInternet
Icom radio
Base station
Remote station
CI-V address : 94
Baud rate : Auto
PC Name : Base PC
IP address : 192.168.0.10
Computer name : BasePC
PC Name : User PC
User ID : USER1
Password : USER0001
USB cable
(Supplied to the
RS-BA1 or a radio)
Router
IC-7300
NOTE:
The password, and other settings in this illustration
are only an example. Please congure the system
using your own settings.
For your convenience:
If you connect an RC-28 remote encoder to the
Remote station, you can use the RS-BA1 and feel
like you are operating the actual transceiver’s main
dial, [TRANSMIT] key and so on.
This guide contains instructions on how to congure the remote control system, and how to remotely control a
radio.
If you are using one of the following radios and connecting to the network directly, see the Installation guide B
(For radios with the Network function). (As of August 2017)
• IC-7851
• IC-7850
• IC-7800 (Firmware version 3.00 or later)
• IC-7700 (Firmware version 2.00 or later)
• IC-7610
Before reading this guide, please nish the installation, using the RS-BA1 Preparations.
See the RS-BA1 Instruction Manual for detailed instructions.

Icom rs-ba1 Specifications

General

Brand	Icom
Model	rs-ba1
Category	Remote Control
Language	English