23
Turning Off the Projector
CAUTION: Do not repeatedly
turn the projector on and off. It
may cause the lamp to explode.
If you want to turn off the projector for a short period of time,
press the standby button on the remote control or keypad. This
turns off the lamp but keeps the projector running. The power/
standby indicator LED (Figure 23) blinks green while the projec-
tor is in standby. To exit standby mode, press the standby button
once. (It takes several seconds for the projection lamp to reach
full power and project the image again.)
To completely power off the projector, press the “O” side of the
power switch. If you want to turn the projector back on immedi-
ately, you should allow at least three minutes for the lamp to
cool.
NOTE: When you disconnect the
projector, always remove the
power cord from the electrical out-
let first, then from the projector.
Downloaded from ProjectorsManual.com Manuals
To Next Page
Loading...
Need help?
General
