Integra DHC-80.1 User Manual

40
Connecting the AV controller—Continued
With u (Remote Interactive), you can use the follow-
ing special functions:
■ Auto Power On/Standby
When you start playback on a component connected
via u, if the AV controller is on Standby, it will
automatically turn on and select that component as
the input source. Similarly, when the AV controller is
set to Standby, all components connected via u
will also go on Standby.
■ Direct Change
When playback is started on a component connected
via u, the AV controller automatically selects that
component as the input source.
■ Remote Control
You can use the AV controller’s remote controller to
control your other u-capable Integra/Onkyo com-
ponents, pointing the remote controller at the AV
controller’s remote control sensor instead of the
component. You must enter the appropriate remote
control code first (see page 143).
Notes:
• Use only u cables for u connections. u cables
are supplied with Integra/Onkyo players (DVD, CD,
etc.).
• Some components have two u jacks. You can con-
nect either one to the AV controller. The other jack is
for connecting additional u-capable components.
• Connect only Integra/Onkyo components to u jacks.
Connecting other manufacturer’s components may
cause a malfunction.
• Some components may not support all u functions.
Refer to the manuals supplied with your other Inte-
gra/Onkyo components.
• While Zone 2 or Zone 3 is on, the Auto Power
On/Standby and Direct Change u functions do not
work.
Notes:
• Before connecting the power cord, connect all of
your speakers and AV components.
• Turning on the AV controller may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV controller into a different branch circuit.
• Do not use a power cord other than the one supplied
with the AV controller. The supplied power cord is
designed exclusively for use with the AV controller
and should not be used with any other equipment.
• Never disconnect the power cord from the AV control-
ler while the other end is still plugged into a wall out-
let. Doing so may cause an electric shock. Always
disconnect the power cord from the wall outlet first,
and then the AV controller.
Connecting Integra/Onkyo u
Components
Step 1:
Make sure that each Integra/Onkyo component is
connected to the AV controller with an analog audio
cable (connection in the hookup examples) (see
pages 29 to 39).
Step 2:
Make the u connection (see illustration right).
Step 3:
If you’re using an MD, CDR, or RI Dock, change the
Input Display (see page 53).
a
Connecting the Power Cord
L R
IN
DVD/BD
L
R
IN
CD
L
R
REMOTE
CONTROL
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., CD player
e.g., DVD player
Step 1:
Connect the supplied power cord to the AV control-
ler’s AC INLET.
Step 2:
Plug the power cord into an AC wall outlet.
To AC wall outlet

Integra DHC-80.1 Specifications

General

Brand	Integra
Model	DHC-80.1
Category	Controller
Language	English