Chapter 4: Programming
106 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
The Advisor Advanced menu
If you attempt to select an option that is not authorized for your PIN (for example,
user menus), the display shows the message:
Note: When an incorrect PIN is entered three times the keypad is locked for 120
seconds.
User code requirement
The system can be configured to prevent the installer from accessing the menus
without permission from the manager. This is required, for example, by EN 50131
regulations. This is set in the menu “8.2.1 User code required” (see page 237).
Challenge code requirement
The system can be configured to prevent the installer from accessing the menus
without permission from the central station operator. In this case the installer gets
a 10-digit request code displayed on LCD when entering the menu. He must call
the central station and provide this request code to the operator. Next, the central
station operator generates a unique challenge code and provides it to the
installer. The installer then uses this challenge code to access the programming
menus.
This code is valid during the time period set in “8.1.3.6 Installer in-time” on page
235.
The option is enabled in “8.2.6 Challenge code” on page 240.
How the menu sections are organized in this manual
The menu entries are numbered in the Advisor Advanced system. This
numbering system is also used in this manual, so menu option 1 “Inhibit zones” is
described in section “1 Inhibit zones”.
The menu number also refers to the key sequence you press to enter it. For
example, if you want to enter menu 1.4 Walk test, you can press 1, 4 after
entering the installer menu.
To Next Page
Loading...
Need help?
General
