Chapter 3: System functions
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 83
Note: For walk test purposes Advisor Advanced stores information on any zone
activation for 4 hours. Therefore if the zone was activated during the last 4 hours
before walk test, it is not included into the list of zones required to test. If each
walk test zone was activated during this time, the walk test is not requested.
Other tests
Communication
To configure automatic communication test or run it manually, use “1.2.6 Test
call opts” on page 130.
Use the following menu to diagnose appropriate communication paths (if
available):
IP: “1.2.7 IP diagnostic” on page 131
GSM: “1.2.8 GSM diagnostic” on page 133
Battery
Use “1.2.9 Battery test” on page 135 to diagnose the panel battery status. The
menu also allows you to configure automatic battery tests.
To Next Page
Loading...
Need help?
General
