---
Operating the sand filter pump under "TIMER" mode
or
manually:
I
,,.,-
-
\
To operate the sand filter pump in "FILTER" mode under "TIMER"
control:
1. Activate the unit:
r
-
o2?c.
(1
-·
lilil
0
_..,_
2 .
@(g)
-~,
Press@button.
Flashing code "00" appears on the LED display,
indicating that the unit is ready to be programmed.
®@
..,
__
@
~
2. Set operating hours for the filter pump:
With code "00" flashing,
press@
button
-
to set the desired operating hours. See the
"Operating Time Table" for the required
operating hours related to each pool size.
Pressi
ng
@)
will increase the time from
01
-
to
12
hours maximum. If you have selected
---
1111
too many hours keep
pressing@
to repeat (
1
10
12
hours
max
per
cycle)
-the cycle. The built-in timer will now activate the Sand filter pump, at the same time each day,
for the number
of
hours you have set.
3.
Lock keypad controls:
With the desired hour value showing, press ® to lock the keypad controls which prevents
unauthorized changing
of
the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will automatically lock it and start
working 10 seconds later.
The sand filter pump is now filtering the water and will stop after the operating hours are
completed.
4. Readjust operating time if necessary:
The operating hours can
be
re-adjusted
if
necessary.
Press®
button and the current
programmed time will flash. Repeat steps 2 to
3.
5.
Stand-by/power saving mode:
• When the cycle ends, the LED display shows
~
"93". The system is now
in
Stand-By mode.
After 5 minutes the system goes into Power
Saving mode and the LED display shows".".
The system will automatically turn itself back
on
in
24
hours.
• While the system
is
in Power Saving mode,
press any button and the system will briefly
display the programmed time and then "93".
al
( 0
l
-
.2..
■
C
..........
J
...
..
,
I
\
To Next Page
Loading...
Need help?
General
