EasyManuals Logo
Home>Intex>Water Filtration Systems>ECO20110-2

Intex ECO20110-2 User Manual

Intex ECO20110-2
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Set operating hours for BOOST:
1.
Press@
button to unlock the keypad. With LED flashing,
press@
! ! llil _
g_
button to set the desired operating hours. Total
of
4 settings: 36 hours,
..£D
.Q,
~
u'\@
.Q,
48 hours, 60 hours and 00 (OFF). Keep pressing ® button to repeat I
~
0
~
....
the cycle.
@) @)
@ @
2. With the desired hour value showing,
press@
button to lock the
___:
- - -
~-
keypad controls. The BOOST indicator light is up when activated. The
system
is
now starting E.C.O. and more chlorine sanitizer production. After boost procedure
has been completed, the system will automatically switch to the normal working mode.
NOTE:
If
you forget to lock the keypad controls, the system will automatically lock it and start
working 10 seconds later.
3. Operating the system in this mode will automati
ca
ll
y activate the pump and chlo
ri
nator, the
LED will always display the remaining operating hours
of
the pump. You need to unlock the
keypad and press @ button to review the programmed boost operating hours.
4. To cancel the boost cycle,
press@
button to unlock the keypad, then
press@)
button
and reset the hour to "00".
Set electrode Self-Clean cycle time:
The default self-clean cycle time is 14 hours. To adjust the self-clean cycle time:
1. Press @ button to unlock the keypad and the L
ED
display is
flashing. Depending on your pool water calcium hardness level, press
@ button to select the self-clean cycle time as below. Total of 3
settings:
14
hours, 10 hours and 06 hours.
Calcium Hardness
Self-clean cycle time
0
-150
ppm
Reverse polarity everv 14 hours
150 - 250 ppm
Reverse polarity every 10 hours
250 - 350 ppm
Reverse polarity everv 06 hours
Oil
@Cg)
®@@@
1,(11).-:0,
- -
~
'---
---
2. With the desired hour value showing, press @ button to lock the keypad controls. The
system will reverse the polarity
of
the electrode (48) every time according to the selected
hours.
NOTE: If you forget to lock the keypad control
s,
the system will automatica
ll
y lock it and start
working 10 seconds later.
SAVE. THESE INSTRUCTIONS
Page
20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex ECO20110-2 and is the answer not in the manual?

Intex ECO20110-2 Specifications

General IconGeneral
BrandIntex
ModelECO20110-2
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals