EasyManuals Logo

Invacare Leo Operating Manual

Invacare Leo
67 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
34
6.5 Error Codes and Diagnostic Codes
Blink
code
FAULT Consequence
for the Scooter
Comments
1
Battery must be
charged
Continues to
drive
The batteries are discharged. Charge the
battery as soon as possible.
2
Battery voltage too
low
Stops driving
The batteries are depleted. Charge
batteries.
If you switch the Scooter off for a few
minutes, the battery can often recuperate
to such a stage that a short journey is still
possible. You should only do this in
emergency, however, because this
causes the batteries to become
excessively discharged!
3
Battery voltage too
high
Stops driving
The battery voltage is too high. If the
battery charger is connected, disconnect
it from the Scooter.
The electronic system charges the
batteries when running downhill and
when braking. This fault is caused when
the battery voltage becomes too high
during this process. Switch the Scooter
off and on again. Switch on the lights to
use up some power.

Table of Contents

Other manuals for Invacare Leo

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Invacare Leo and is the answer not in the manual?

Invacare Leo Specifications

General IconGeneral
Maximum Speed8 km/h
Weight Capacity136 kg
Ground Clearance7 cm
Battery2 x 12V
Seat Width47 cm
Seat Depth41 cm (16.1 inches)
Maximum Safe Slope10 degrees
Turning Radius43.3 inches (110 cm)

Related product manuals