ISHIDA WM-NANO Service Manual

Chapter 4 Hardware (Electrical)
Chapter 4 Hardware (Electrical)
4.1 Electrical Unit Board Configuration
When a worker put his/her hand inside the machine body, be sure to press the
emergency stop switch.
Pay full attention that the DC 24V power source for the logic system does not turn
off even though the emergency stop button is pressed.
When the fuse blew off, be sure to replace the fuse with the specified one.
4.1.1 Alignment of Each Control Unit
Wrapping control unit
Front: Weighing unit (inside)
4-1

ISHIDA WM-NANO Specifications

General

Brand	ISHIDA
Model	WM-NANO
Category	Packaging equipment
Language	English