Chapter 3 Adjustment Mode
3.2 Adjustment
3.2.1 Adjusting Clamp Position
■ Clamp plate mounting position
When the clamp plate of the film conveying unit is removed or replaced, the clamp plate must be fixed in a
proper position.
● Points of caution in mounting the clamp plate.
・Mount the clamp plate apart as much as possible from the round belts on the side of catching film.
Maintain space between the clamp plate and the round belts as much as possible. If space is insufficient,
the round belts may run off the clamp plate and get stuck on the plate, making it impossible for the belts
to return to their original positions
Center clamp plate
Left and right clamp
plates
Left and right clamp
lates
Center clamp plate
Clamp plate
Round belt
Film
Mount the clamp plate at an upper position
as much as possible to maintain space.
The round
belts may run
off.
3-29
To Next Page
Loading...
Need help?
General
