Chapter 5 Troubleshooting
ID NO.
TITLE ERROR CONTENTS SOLUTION
0293 FREE MSG.13
MASTER ISN’T
PROGRAMMED
Free Message 13 that was called up
is not programmed in the Free
Message 13 master.
Called Free Message 13 No. does
not exist in the internal memory.
[SET] Æ Only releasing the error
message.
[DELETE] Æ Deletes the Free
Message 13 of the PLU.
0294 FREE MSG.14
MASTE ISN’T
PROGRAMMED
Free Message 14 that was called up
is not programmed in the Free
Message 14 master.
Called Free Message 14 No. does
not exist in the internal memory.
[SET] Æ Only releasing the error
message.
[DELETE] Æ Deletes the Free
Message 14 of the PLU.
0295 FREE MSG. 15
MASTER ISN’T
PROGRAMMED
Free Message 15 that was called up
is not programmed in the Free
Message 15 master.
Called Free Message 15 No. does
not exist in the internal memory.
[SET] Æ Only releasing the error
message.
[DELETE] Æ Deletes the Free
Message 15 of the PLU.
0296 LINK PLU ERROR Link PLU error
Called Link PLU does not exist or
the setting of Link PLU is not correct.
[OK]
0297 FILM IS NOT
GETTING WARM
Film is not getting warm.
1. Operator tried to start the
production before the film get
warmed up after turning on the
power of the machine.
2. Setting of the fan heater is not
proper. (Ex. Turned Off, Set
temperature is too low, etc.)
3. Setting of temperature check
function is not proper. (Ex.
Yes/No, the minimum
temperature is too high, etc)
4. The temperature does not rise
up due to the broken fan heater.
[OK]: Release the error with
maintaining the function ON.
[CANCEL]: Release the error with
turning off the function.
5-9
To Next Page
Need help?
General