Chapter 5 Troubleshooting
ID NO.
TITLE ERROR CONTENTS SOLUTION
0482 FAILED TO FEED
FILM
It failed to feed the film.
1. When the cutter tries to move, the
film set arm is not back to the home
position.
The film set arm home position
sensor is cutting the sensor when
the cutter tries to move. (Sub-error
No. 0, 9,10,11and 12 happens.)
2. Film is not set, or film wraps around
the film feeder roller and film was
not fed.
Æ
Sub-error 100 – 102 happens.
3. Film detect sensor is broken and
cannot detect the film properly.
Æ
Sub-error 100 – 102 happens.
<SUB ERROR>
0000/0001: Film set arm is not back at
the home position when the
cutter started to move at
normal wrapping/Film
feeding.
0009/0012: Film set arm is not back at
the home position when the
cutter started to move at
RETURN/REMOVE.
0010: Film set arm is not back at the
home position when the cutter
started to move at UNIT TEST.
0100: Both film-detecting sensors at
front and rear did not detect the
film between the film feeding
started and time out of the
detection.
0101: Film-detecting sensor at front did
not detect the film between the
film feeding started and time out
of the detection.
0102: Film-detecting sensor at rear did
not detect the film between the
film feeding started and time out
of the detection.
[RETURN]
- When sub-error No. is 100 –102, it is
necessary to open the left side cover
to release the error.
- When the film-detecting sensor is set
to OFF, this error does not happen.
5-22
To Next Page
Loading...
Need help?
General
