Chapter 5 Troubleshooting
ID NO.
TITLE ERROR CONTENTS SOLUTION
0494 PROBLEM ON
WRAPPING PART
A problem happened at wrapper
side.
The wrapper software is not
downloaded. Or the wrapper
software cannot be recognized. (It
could not download properly.)
* The machine can work as Printer
only after releasing the error.
<SUB ERROR>
0000: Check SUM for application
program does not match.
0001: Failed to transfer to
application.
0009: Check SUM for flash memory
program does not match.
[OK]
Download the wrapper application.
- Wrapper application 1 when
sub-error is 0000.
- Wrapper application 2 when
sub-error is 0009.
<Check Point>
1. Check if the model setting is correct.
2. Check XJ8 of short-circuit pin
P-1004 for model identification.
0495 SUM VALUE FOR
RECEIVING IS
ABNORMAL
SUM value was abnormal when
downloading the wrapper.
SUM values between Program data
that wrapper received and Code do
not match.
[OK]
Retry downloading.
0496 WRITING FOR
FLASH ROM IS
BUSY
It took too long to complete writing
Flash ROM.
It does not complete writing into
Flash ROM when downloading the
wrapper application even after a
certain time.
[OK]
Retry downloading.
0497
FAILED IN WRITING
IN FLASH ROM
Failed in writing in flash ROM when
downloading wrapper program.
It failed to write in flash ROM when
downloading wrapper program.
<SUB ERROR No.>
0001: Failed to delete flash ROM.
0002: Failed to write application
program in flash ROM.
0003: Failed to write application
program SUM value in flash
ROM.
0004: Code sequence before writing
flash ROM slipped.
0005: It received the download
command even it is not at the
boot mode when application
program is running.
[OK]
Retry downloading.
5-24
To Next Page
Loading...
Need help?
General
