Output Commands
Copyright© Itech Electronic Co., Ltd. 30
Query syntax
OUTPut:PARallel [:STATe]?
Note: If channel 3 and channel 1 or channel 2 are in series or parallel or
synchronized state. Then an error occurs after this command is executed.
[SOURce:]CHANnel:OUTPut[:STATe]
This command is used to control the output state (ON/OFF) of the current
channel. Before using this command, you must switch to the appropriate
channel firstly.
Command syntax
[SOURce:]CHANnel:OUTPut[:STATe] <bool>
Arguments
0|1|ON|OFF
*RST Value
OFF
Query syntax
[SOURce:]CHANnel:OUTPut[:STATe]?
Returns
0|1
[SOURce:]CHANnel?
This command is used to query the current channel. This command only works
when the command option in Config menu is selected as EXT1.
Arguments
None
Returns
CH1|CH2|CH3
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]
This command is used to set the current value of current channel.
Command syntax
[SOURce:]CURRent[:LEVel] <NRf>
Arguments
num|MIN|MAX|DEF
Setting range: 0~rated value
To Next Page
Loading...
Need help?
General
