ITech IT6322A Programming Guide

Output Commands
Copyright© Itech Electronic Co., Ltd. 34
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRe
ment]
This command is used to set the voltage step.
Command syntax
[SOURce:] VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
Arguments
Voltage value
Unit
kV|V|mV
Query syntax
[SOURce:] VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]?
[SOURce:]VOLTage[:LEVel]:TRIGgered[:IMMediate][:I
NCRement]
This command is used to set the trigger voltage. Only applicable to IT6300A/B
series models.
When the instrument receives a trigger signal (*TRG command or USB or GPIB
hardware level trigger signal), the instrument automatically sets the voltage to
the voltage value set in this Trigger command.
Command syntax
[SOURce:] VOLTage[:LEVel]:TRIGgered[:IMMediate][:INCRement]
Arguments
Voltage value|Min|Max|Def|Up|Down
Unit
kV|V|mV
Query syntax
[SOURce:] VOLTage[:LEVel]:TRIGgered[:IMMediate][:INCRement]?
[SOURce:]VOLTage:PROTection:STATe
This command is used to set the overvoltage protection status of the power
supply.
Command syntax
[SOURce:] VOLTage:PROTection:STATe <bool>
Arguments
0 | 1 | ON | OFF

ITech IT6322A Specifications

General

Brand	ITech
Model	IT6322A
Category	Power Supply
Language	English