To Next Page

To Previous Page

IEEE-488 Commands

Chapter10 IEEE-488 Commands

*CLS

This command clears the following registers:

⚫ Standard event register

⚫ Query event register

⚫ Operation event register

⚫ Status byte register

Command syntax

*CLS

Arguments

None

*ESE

This command can set the parameter of standard event enable register.

Setting parameter can determine which bit of standard event register is 1

and the byte will enable ESB of status byte register is 1.

Command syntax

*ESE <NRf>

Arguments

0~255

Default set

Refer to *PSC command

Example

*ESE 128

Query syntax

*ESE?

Returns

<NR1>

*ESR?

This command can read the value of standard event status register. After

executing this command, standard event status register is reset. Bit

definition of standard event status register is as the same as the

standard event status enable register.

ITech IT6322A Programming Guide

Other manuals for ITech IT6322A